Electrical Engineer

We are seeking a hands-on Electrical Engineer for the development, integration, characterization, and troubleshooting of subsystem-level electrical testers. This role is highly technical and execution-focused, with a strong emphasis on practical hardware engineering.

The ideal candidate should have 4–8 years of recent hands-on experience in designing and building electronics and semi-automated test systems, integrating hardware/software, and debugging complex electrical issues.

Key Responsibilities

Tester Development & Integration

• Design, build, and maintain subsystem characterization testers:

  • Power distribution and protection
  • Signal conditioning and measurement
  • Control, interlocks, and safety circuits

• Develop custom test hardware (fixtures, wiring harnesses, test jigs)

• Integrate testers with:

  • Mechanical fixtures
  • Sensors, actuators, power electronics, embedded systems
  • Lab and production environments

Electrical Characterization & Debugging

• Perform subsystem electrical characterization:

  • Voltage/current measurements
  • Signal integrity and timing analysis
  • Noise and grounding

• Troubleshoot issues in:

  • Analog and digital electronics
  • Power supplies, converters, motor drives
  • Communication interfaces (I²C, SPI, UART, CAN, Ethernet, USB)

Hands-On Lab Execution

• Execute testing in lab environments:

  • Bring-up of testers and subsystems
  • Debug under schedule pressure
  • Support verification and troubleshooting

• Use lab equipment:

  • Oscilloscopes, logic analyzers, DMMs, power analyzers
  • Environmental and stress testing setups

Required Qualifications

• Bachelor’s degree in Electrical/Mechanical Engineering or related field

• 4–8 years of hands-on experience in:

  • Test system development
  • Subsystem-level electrical integration & characterization

• Experience in:

  • Analog & digital circuit design/debugging
  • Power electronics (low-voltage/high-current systems)

• Strong troubleshooting skills using lab tools

• Experience across full lifecycle: concept → build → bring-up → support

Strongly Preferred

• Embedded subsystems
• Motion control systems
• Sensor & transducer technologies
• Power distribution systems
• Communication protocols (CAN, Ethernet, RS-232, RS-485)

Preferred Qualifications

• Medical device experience
• Familiarity with industry standards
• Exposure to PLM tools and change management
• EMI/EMC knowledge in harness design

Key Skills

• Wire harness design & routing
• Electrical schematics interpretation
• NX Routing (3D harness design)
• Component selection & validation
• Strong analytical and communication skills